
CDL Skills Test
By Dudley’s Driving Center Inc.
What Is the CDL Pre-Trip Inspection?
Definition: The pre-trip inspection is the first part of the CDL skills test, in which you inspect the vehicle and explain each check to the examiner.
It’s the first of the three parts of the CDL skills test, and you have to pass it before you move on to basic control skills. Virginia’s CDL manual calls it the vehicle inspection test. You’re tested only on the items on the manual’s inspection checklist, and for each one you must name it, point to or touch it, and explain what you’re checking for. The way to learn it is to practice aloud, in the same order every time, on the truck you’ll test in. If the vehicle has air brakes, give the four-part air brake check extra time, because getting it wrong is an automatic failure.
Key Takeaways
It’s a spoken test. You name the part, point to or touch it, and say what you’re checking for.
Only checklist items are tested, and you may carry the manual’s checklist during the test as long as nothing extra is written on it.
Failing to explain and perform all four parts of the air brake check correctly is an automatic failure.
Practice out loud, in a fixed order, on the vehicle you’ll test in.
How the Pre-Trip Inspection Works
What the examiner is listening for
For each item you must name it, point to or touch it, and fully explain what you’re inspecting it for. If you leave one of those out, you get no credit for the item. You’ll be asked to inspect one axle, but the manual tells you to be ready for any of them. A vehicle with parts that have been marked or labeled can’t be used for the test.
What’s on the Class A checklist
The checklist for a tractor-trailer has 32 items, grouped by where you’re standing:
Area | Items |
|---|---|
In the cab, engine start | Air or hydraulic brake check, parking and trailer brake check, service brake check, lighting indicators, emergency equipment, windshield and mirrors, wipers and washers, heater and defroster, horn |
Lights | All external lights |
Front and engine area | Lenses, fluid levels, fluid and air leaks, steering system |
Steering axle | Tires, rims, lug nuts, springs and mounts, air bags and shocks, brake lines or hoses, brake contaminants |
Side of vehicle | Lenses and reflectors, mirrors, battery, fuel and DEF tanks, frame and tandem release |
Coupling | Air and electric lines, fifth wheel, kingpin and apron, locking and safety devices |
Trailer | Landing gear, reflective tape, rear lenses and reflectors |
Straight trucks and buses have their own checklists in the same section of the manual. Use the one for the vehicle you’ll test in.
The air brake check
This is the one checklist item that fails the whole inspection if it’s wrong, so learn it as a fixed routine.
Part | What you do | What you’re looking for |
|---|---|---|
1. Air gauge and governor cutout | Build air pressure until the governor cuts out | Cutout at about 120 to 140 psi, or the manufacturer’s level |
2. Air leakage rate | Engine off, key on, parking brake released, hold the foot brake for one minute once the gauge settles | A drop of no more than 3 psi for a single vehicle or 4 psi for a combination |
3. Air warning devices | Fan the brake pedal to bleed off air | The low-air warning comes on before pressure falls below 55 psi |
4. Emergency brakes | Keep fanning | The parking brake valve pops out between 20 and 45 psi, or the manufacturer’s level |
Vehicles with hydraulic brakes have a hydraulic brake check instead, and the same automatic-failure rule applies to it.
A practice method
Print the checklist for your vehicle class from Section 11 of the Virginia CDL manual.
Learn one area at a time, and always walk the vehicle in the same direction.
Use one sentence pattern for every item: the name of the part, then what you’re checking it for.
Say it out loud every time, to another student if you can.
Drill the air brake check on its own until the order and the numbers come without thinking.
Finish with full run-throughs holding only the clean checklist, since that’s all you’ll have on test day.
Who Needs to Learn the Pre-Trip Inspection?
This guide fits if:
You’re preparing for a Class A or Class B skills test in Virginia.
You can identify the parts but stall when you have to describe them.
You’ve failed the inspection once and want a routine to rebuild from.
It isn’t enough on its own if:
You’re testing in a bus or school bus. Those checklists add passenger items such as emergency exits and seating.
You haven’t had time on the actual vehicle. The parts sit in different places on different trucks, so photos and videos only get you partway.
What to Check Before Test Day
Check | You’re ready when... |
|---|---|
Full inspection | You can do it start to finish with only the clean checklist in hand |
Wording | Every item gets a name, a point or touch, and a reason |
Air brake check | You can perform all four parts in order and say each pressure |
Safety habits | You set the parking brake without being reminded |
Vehicle | You’ve practiced on the truck you’ll test in |
Common Mistakes
Studying silently. Students who only read the list tend to freeze when they have to say it.
Naming a part without saying what you’re checking for. The manual gives no credit for that item.
Mixing up the air brake check order or numbers. This one is an automatic failure.
Forgetting the parking brake. The manual uses it as its example of an unsafe act, which can end the test.
Writing notes on the checklist. Check marks are allowed, and nothing else is.
Decision Rule
If you can complete the whole inspection aloud twice in a row with only the clean checklist, and perform the air brake check in order with the correct pressures, this part of the test is ready. If you still need prompts on either one, keep practicing before you schedule.
Example (Illustrative)
This example is illustrative. A weekend student knows the engine area well but keeps skipping items on the trailer. The student starts walking the truck the same way every session and says each item to a classmate who holds the checklist. After a few sessions the trailer items stop dropping out. The air brake check still takes two tries, so the student runs it alone at the start of each practice until it comes out in order.
Frequently Asked Questions
Can I use a checklist during the CDL pre-trip inspection in Virginia?
Yes. Virginia’s CDL manual says you may use the vehicle inspection checklist printed in the manual and check off items as you finish them. No other markings or writing are allowed on it.
What is an automatic failure on the pre-trip inspection?
Failing to explain and perform all four parts of the air brake check correctly is an automatic failure, and so is getting the hydraulic brake check wrong on a vehicle that has hydraulic brakes. An unsafe act or not following the examiner’s instructions can also end the test.
Is the pre-trip inspection different for Class B?
The method is the same, but a straight truck has its own checklist with no trailer or coupling items. Buses and school buses use a checklist with extra passenger items.
What happens if I fail the pre-trip inspection?
The test stops there. The three parts are taken in order, and you must pass each one before moving to the next. You can test again on a later business day.
The Bottom Line
The pre-trip inspection rewards routine more than mechanical knowledge. Learn the checklist for your vehicle, say every item the same way each time, and treat the air brake check as its own drill. When you can do the whole thing aloud twice with a clean checklist, you’re ready for the first part of the test.
Where to Go Next
Class A CDL Training at Dudley’s
Sources
Virginia DMV, Commercial Driver’s License Manual (DMV 60A), Sections 1, 5 and 11, version dated July 20, 2026, checked November 15, 2026
Virginia DMV, Virginia Commercial Driver’s Manual, checked November 15, 2026
Virginia DMV, CDL Skills Tests, checked November 15, 2026
Test content is set by the Virginia DMV and can change, so check the current manual before you test. Schedules and tuition are subject to change.
Call us or stop by 10860 Warwick Blvd in Newport News. We’ll help you work out your next step.
Call (757) 766-0500

